demo_bendP

1. Symbol:

1. Demo kit Bend:

a) Parameters:

Name	Description	Unit	Default
Type	Type of bend(M0, M1, M2 or M3)	nil	M1
Width(w)	Width of the bend	um	20
Angle	Angle of the bend	degree	90
Miter	Miter of the bend	nil	0.5

b) Range:

Type0 (M0) ; M0 bend ; Width, w=(5 to 50 um) ; Angle= (-90 to 90 deg, but != 0 deg ) ; Miter (0 to 1.0)

Type1 (M1) ; M1 bend ; Width, w=(5 to 50 um) ; Angle= (-90 to 90 deg, but != 0 deg ); Miter (0 to 1.0)

Type2 (M2) ; M2 bend ; Width, w=(5 to 50 um) ; Angle= (-90 to 90 deg, but != 0 deg ); Miter (0 to 1.0)

Type3 (M1+M2) ; M1+M2 bend; Width, w=(5 to 50 um) ; Angle= (-90 to 90 deg, but != 0 deg ); Miter (0 to 1.0)

2. Notes:

a) The Angle of the bend is fixed at 90 degrees.

b) Transmission lines on the same layer should be connected to the bend chosen on a particular layer.

c) Available both in schematic and layout with synchronization.